If you’ve purchased a new LED steering wheel from us, you may wish to know the following!
How to install the steering wheel, wires, and activate the display
When you receive your new LED steering wheel, you will find two wires. These wires connect to the buttons of your vehicle.
Remove the airbag, and buttons and find the wiring loom attached to it. The red wire must be connected to a positive power source, and the black wire must be connected to a negative power source. You may need a multimeter to find a positive (+) and negative (-) source.
Once you have found the wires you are going to connect these to, detach the cars battery, and connect these wires.
Plug in the OBD connector. It is important that the wires are connected correctly, and the OBD connector is securely fixed in, otherwise this can cause the display to loose power or connection.
Reattach the cars battery, and turn on the ignition. This may take a few seconds to activate, and connect to the OBD. If this does not turn on, you can hold both buttons for 5 seconds to activate it.
Menus for the display:
To enter the menu, press the right key down until you find the menu section. Long press the right button down. This will enter the menu. In this menu you can alter the RPM redline, change the display colours and features of the display.
What if my display does not connect when it is turned on?
If your display does not connect to the car, this will need a simple battery reset.
Simply remove the OBD connector, and cars battery, and wait 30 seconds. Once you have done this, reconnect it, and plug the OBD reader back in. This will perform the reset, and connection can then be made.
Assistance with steering wheels:
If you have any questions, or require any help, please use the contact us page and get in touch! We’d be happy to help.