Runs circles around the rest.
Customising the look of your vehicle has never been easier. The new and improved Ambient Ring delivers over 200 New colour styles including Half & Half Mode, Colour Chase, and sets a new standard with Rainbow Mode.
Superior look.
Autobeam takes it to a whole new level. With over 2x as many LEDs than others, it's twice as bright. The Improved Ambient Ring also incorporates an all-new opaque dispersion material, which radically reduces the look of single LED's within the housing as well as providing an IP69 waterproof rating.
Change it up, with a tap.
Just download the LED app onto your smartphone and you'll be able to control the colour, mode and brightness of your stylish new Ambient Rings using Bluetooth.
No glue, no sealant, no mess.
Using Built-in 3M® backing adhesive, the rings stick directly to your fog light unit. With this innovative design forget waiting around for sealant to dry, as installation takes seconds.
- New all Copper PCB
- New opaque light dispersion
- New IP69 ring Waterproofing
- New IP69 fuse
- New IP69 connector
- New IP69 Resin filled controller
- Colour Chase modes
- Colour change modes
- Static Colour modes
- Overcurrent protection
- Low power consumption
- High lumen output
- App-Controlled
Voltage: 12v
App: Magic LED IOS | Android
Diameter:
60mm | Inner size: 50mm - Outer size: 60mm
70mm | Inner size: 60mm - Outer size: 70mm
80mm | Inner size 70mm - Outer size 80mm
90mm | Inner size 80mm - Outer size 90mm
180mm | Inner size 160mm - Outer size 180mm
Wiring connections
Red: Battery +
Black: Battery -
App control: Magic LED IOS | Android
Please do not attempt to apply in cold conditions (less than 10°C) as this can affect the adhesive.
Before applying, clean the surface area with an alcohol-based cleaner (tar & glue remover or similar) and allow to dry.
Once the surface is clean and dry gently heat the sticky-back and the surface it is to be applied to using a hair dryer or heat gun (take care using a heat gun if near painted surfaces). This will aid the adhesive process.
Align the rings in the correct position and apply pressure for a minimum of 30 seconds.
Do not pressure wash for at least 24 hours.
